Toggle

Copyright (C) 2013 Christopher Roberts

Licensed under the GPL v3 - see LICENCE.md

Description

OpenSCAD design for a shock cord toggle.

This is a toggle that would go on each end of a length of bungee cord. In particular it is designed to replace the toggles that you get on rubber dinghies to hold the oars in place.

Instructions

Download and edit the .scad file with your chosen parameters. Only the toggle radius needs changing, as the rest are pre-set based on that, but you can edit any of the global variables as you wish.

Generate STL and Gcodes in the normal way and print using your 3D printer.

Cut bungee cord to length and insert through hole.

Tie a tight knot in the end with the large hole and pull knot into the body of the toggle. Insert the bung in the large hole.

NameSizeLast UpdatedActions
licence.md 34.3 KB1 year, 2 months ago57 0
readme.md  827 bytes1 year, 2 months ago63 0
toggle-dbl.stl 2.0 MB1 year, 2 months ago61 0
toggle-sgl.stl 2.0 MB1 year, 2 months ago57 0
toggle.jpg 300.9 KB1 year, 2 months ago72 0
toggle.scad 2.6 KB1 year, 2 months ago62 0